28 February 2017 Installation and Planning
CY460_Operational_Manual_405 Page 33 of 218
6. Check that the Digital Audio signal is as configured in the menu, and that selecting
and editing entries in the menu by using the rotary/push control, the configuration of
the Digital Audio signal changes accordingly.
7. Repeat steps 3 – 6 for menu selection:
< SDI 1 Pattern Right = Audio 02 > on SDI1 Pattern video output.
8. Repeat steps 3 – 6 for menu selections:
< SDI 1 Pattern Left / Right = Audio 03….16 > on SDI1 Pattern video output.
9. Repeat steps 3 – 6 for menu selections:
< SDI 1 Black Left / Right = Audio 01….16 > on SDI1 Black output.
10. Repeat steps 3 – 6 for menu selections:
< SDI 2 Pattern Left / Right = Audio 01….16 > on SDI2 Pattern video output.
11. Repeat steps 3 – 6 for menu selections:
< SDI 2 Black Left / Right = Audio 01….16 > on SDI2 Black output.
12. Return to the Top Level menu using the [ Back ] button.
AES / EBU Audio Outputs:
Note: AES/EBU Audio Outputs are only available when the multifunction sub-module is
installed.
Note: Audio channels on the AES outputs are arranged as stereo pairs on each output:
AES 1 01 …. 02
AES 2 01 …. 02
etc, to
AES 8 01 …. 02
Connect a suitable Breakout cable/box to the 30-pin Multiway connector on the rear panel.
From the Top Level menu:
1. Select < -Audio >.
2. Select < Audio AES1 Left = Audio 01 >.
3. From the Breakout cable/box, connect AES Audio Channel 01 to your Digital Audio
Analyser input.
4. Set the Digital Audio Analyser to display the status of the audio data, and to receive a
signal through the connected input.
5. Check that the analyser does not report any data errors, etc.
6. Check that the Digital Audio signal is as configured in the menu, and that selecting
and editing entries in the menu by using the rotary/push control, the configuration of
the Digital Audio signal changes accordingly.
7. Repeat steps 3 – 6 for menu selection
< Audio AES1 Right = Audio 02 > and breakout connection AES Audio
Channel 02.
8. Repeat steps 3 – 6 for menu selections:
< Audio AES 2….6 Left / Right = Audio 03….12 > and breakout connections
AES Audio Channel 03 through 12.
9. AES7 & AES8 Audio outputs will only appear on the rear panel multiway connector
of the sub-module if the relevant menu items have been suitably configured. See
“System Functions” below for more details on where these settings are.
10. Repeat steps 3 – 6 for menu selections:
< Audio AES 7….8 Left / Right = Audio 13….16 > and breakout connections
AES Audio Channel 13 through 16.
11. Return to the Top Level menu using the [ Back ] button.
To Next Page