28 February 2017 Installation and Planning
CY460_Operational_Manual_405 Page 34 of 218
Analogue Audio Outputs:
Note: Analogue Audio Outputs are only available when the multifunction sub-module is
installed.
Note: Audio channels on the Analogue Audio outputs are arranged as a stereo pair:
Analogue 01 … 02
Connect a suitable Breakout cable/box to the 30-pin Multiway connector on the rear panel.
From the Top Level menu:
1. Select < -Audio >.
2. Select < Audio Analogue1 Left = Audio 01 > [2
nd
to last entry in the list].
3. From the Breakout cable/box, connect Analogue Audio Channel 01 to your Analogue
Audio Analyser input or to an oscilloscope.
4. Set the Analogue Audio Analyser / oscilloscope to display the audio signal, and to
receive a signal through the connected input.
5. Check that the Analogue Audio signal is as configured in the menu, and that selecting
and editing entries in the menu by using the rotary/push control, the configuration of
the Analogue Audio signal changes accordingly.
6. Repeat steps 3 – 5 for menu selection:
< Audio Analogue1 Right = Audio 02 > [Last entry in the list] and breakout
connections Analogue Audio Channel 02.
7. Return to the Top Level menu using the [ Back ] button.
Time & Timecode Settings
Each video output has its own dedicated Timecode generator, which can be offset from the main
SPG Time. Additionally, there are dedicated LTC outputs which can be similarly offset. There
are also several Timecode system-related setup screens. This procedure will acquaint the user
with the available options. See Figure 1.2c in Section 1.0 : Getting Started for a functional
diagram of the Timecode system.
The following Timecode menu screens are available:
SDI 1 & SDIBlack 1 Timecode
SDI 2 & SDIBlack 2 Timecode
Composite 1 VITC
Black 1 VITC
Tri-Sync Black 2 VITC
Tri-Sync Black 3 VITC
Tri-Sync Black 4 VITC
LTC 1 Timecode
LTC 2 Timecode
LTC 3 Timecode
LTC 4 Timecode
SPG Time
UTC DateTime
GPS DateTime (UTC)
NTP DateTime (UTC)
Analog REF VITC (UTC)
Digital REF TC (UTC)
Summer DST Event (UTC)
Winter DST Event (UTC)
Leap Second Event (UTC)
From the Top Level menu:
To Next Page