15
www.starweb.com.au Covert Security & Wildlife Monitoring T.C. - User Manual March.2013
11 Trouble - Shooting
It is not uncommon for users to accidentally re program their camera with conflicting
instructions which can result in unusual or erratic camera behavior.
If you are having problems of this nature we recommend the following procedure prior to
contacting us.
Install a new set of 12 x AA alkaline batteries & SDHC card (making sure that the card is not
locked). Move the camera’s Power button to the SET UP position, press the MENU button &
scroll across to highlight “SYS”. Scroll down & select the “FORMAT” option, follow the
instructions & format the SD card. Using the same procedure, this time select “DEFAULT
SET” & reprogram the camera to its default settings.
Re-test your camera, refer to the table below & if you require additional help email
howard@starweb.com.au for further assistance.
Camera will not enter SETUP mode
Power switch not in SETUP position
• SD Card not loaded
• SD Card write protected
• Batteries flat
Camera takes pictures all day
Time lapse mode ON
• Interval set to 0 delay
Poor Image Quality
Dirty lens window
Washed out daytime images
Camera angled to high sun in picture
Water inside housing
Battery flat or discharged
To Next Page
Loading...
