COX Custom 4 - Remote Setup Using Device Code Entry; Remote Setup by Searching for Your Code

Yamaha: 0
Remote Setup Using Device Code Entry
1. Turn on the device you wish to program.
2. Press and release the key for the DEVICE to be programmed.
3. Find your device and brand from the listing below.
4. NOTE: If the brand for your device is not listed please proceed to Searching for Your Code.
5. Press and HOLD MUTE + SELECT simultaneously until the device key selected in step 2 blinks
twice, then release both keys.
6. Enter in the first 4 digit code listed for your brand.
7. Press the POWER key to test device control. If the device turns off, you have found the correct
code and it was saved automatically.
8. If the device does not turn off, repeat steps 2 through 7 trying each code listed for your brand
until you find the correct device code. If none of the device codes work for your brand try
Searching for Your Code.
Remote Setup by Searching for Your Code
1. Turn on the device you wish to program.
2. Press and HOLD MUTE + SELECT simultaneously until the DEVICE key blinks twice, then release
both keys.
3. Press and release the key for the device to be programmed. DEVICE key LED stays on.