CRADLEPOINT MBR1400 | USER MANUAL – Firmware version 5.0
© 2013 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 162
GSM Technology
Auto Auto 3G Force 4G
✔ ✔ ✔ ✔ ✔ ✔
AT Config Script: Enter the AT commands to be used for carrier specific modem configuration settings. Each command
must be entered on a separate line. The command and associated response will be logged, so you should check the
system log to make sure there were no errors.
NOTE: AT Config Script should not be used unless told to do so by your modem's cellular provider or by a support technician.
AT Dial Script: This is included for legacy devices only. Most users will not use this option. Go to SIM/APN/Auth
Settings instead if you need to select a specific Access Point Name.
If you do need this option for older devices, enter the AT commands to be used in establishing a network connection.
Each command must be entered on a separate line. All command responses must include “OK” except the final command
response, which must include “CONNECT”.
Example:
AT
ATDT*99***2#
To Next Page
