Bevel Cutting
Bevel cutting is the cutting operation to
cut a desired angle on the edge of the
work piece.
To perform bevel cutting operation on a
jointer, first of all make sure that the
work-piece is dry, clean and free of nails
or any kind of metal that can damage the
OPERATIONS AND ADJUSTMENTS
It is recommended to set the cutting
depth between 1/16” and 1/8” when
doing bevel cutting.
Now, set the fence to your desired angle
and start the jointer. Use push blocks to
push the stock over the cutter-head. If
the stock is cupped, make sure to put the
concave face of the stock flat on the in-
feed table. See figure 15
cutter-head.
Figure 15: Bevel Cutting
The fence of the jointer can be set to
different angles and it has a stop that
can hold the fence in that position so
that it doest not move while
operation.
16
To Next Page
Loading...
Need help?
General
