CT200-6” & CT201-8” Jointers
Specific Safety Instructions
¾ Always lock the mobile base
before operating the machine.
¾ IF you are not familiar with the
operations of a jointer, you should
obtain the advice and/or
instructions from a qualified
professional.
¾ Always use push blocks when
jointing stock that does not
provide a reasonable distance of
safety for your hands.
¾ Never make cuts deeper than 1/8” in
a single pass to prevent
overloading the machine and to
prevent dangerous kickback.
¾ Always make adjustments with
the power OFF.
¾ Maintain the proper relationship of
in-feed and out-feed table surfaces
and the cutter head knife path.
¾ All operations must be performed
with the guards in place to ensure
safety.
¾ Never back your workpiece into the
spinning cutterhead..
¾ Never allow your hands to pass
directly over the cutter head.
¾ Always make sure that the
exposed cutter head behind the
fence is guarded particularly when
jointing near the leading edge
such as in rabbetting.
¾ Always inspect your stock before
feeding it over the cutterhead.
IMPORTANT: The safety instructions given above can not be complete because the
environment in every shop is different. Always consider safety first as it applies to
your individual working conditions.
4
To Next Page
Loading...
