PROPER GROUNDING
Grounding provides a path of least
resistance for electric current to reduce the
risk of electric shock.
CX424 is for use on a normal 120 volt
circuit. Make sure that the machine is
connected to an outlet having the same
configuration as the plug. If an adaptor plug
is used, it must be attached to the metal
screw of the receptacle. To prevent
electrical hazards, have a qualified
electrician ensure that the line is properly
wired.
The dust collector should be wired with a
plug having 3 prongs to fit a 3 prong
grounded receptacle as shown in figure-2.
Do not remove the grounding prong to fit it
into a 2 pronged outlet.
Figure-2 120-Volts outlet for CX424
It is strongly recommended not to use
extension cords with your CX424. Always
try to position your machine close to the
power source so that you do not need to
use extension cords.
In case if you really find it necessary to use
an extension cord, make sure the extension
cord does not exceed 50-feet in length and
the cord is 14-gauge to prevent motor
damage.
WARNING!
Improper connection of the equipment-
grounding conductor can result in a risk
of electric shock. Check with a qualified
electrician if you are in doubt as to
whether the outlet is properly grounded.
To Next Page
Loading...
Need help?
General
