Craftex CX06SC - Setup; Unpacking

8
SETUP
Before starting setting up the machine you
need to read and understand this user
manual completely. For the protection of
your eyes you should wear safety glasses.
The unpainted surfaces of the jointer are
coated with rust prevention waxy oil and
you will want to remove this before you
begin assembly. Use a solvent cleaner that
will not damage painted surfaces.
UNPACKING
The machine is properly packaged in a
carton for safe transportation. When
unpacking, carefully inspect the crate and
ensure that nothing has been damaged
during transit. Open the crate and check
that the machine is in good condition. The
machine is heavy and you should use a fork
truck or get assistance to move the
machine for safe moving method. You
should also clean the cutter-head, in-feed
and out-feed tables, and the fence before
assembly and operation.
The hardware (screws, washers & etc)
might be shipped in a plastic bag. After the
machine has been un-packed, check that
all loose parts and hardware are present.
CX06SC CX08SC
Figure-1 Minimum work space for jointers
WARNING
CX06SC/CX08SC is a heavy machine.
Do not over-exert yourself. Use fork
truck or other devices for safe moving.
IMPORTANT
When setting up your machine, you will
want to find an ideal spot where your
jointer will most likely be positioned most
of the time. Consider your complete work
environment as well as working
comfortable with the jointer before
placing your machine in the ideal spot.