9
PROPER GROUNDING
Grounding provides a path of least
resistance for electric current to reduce the
risk of electric shock.
CX06SC is equipped with a 110-Volt and
CX08SC is equipped with a 220-Volt single
phase motor which features a 3-conductor
cord and a 3-prong grounded plug to fit a
grounded type receptacle. Make sure the
cord is plugged into a properly installed and
grounded power outlet.
To prevent electrical hazards, have a
qualified electrician ensure that the line is
properly wired.
Figure-2.1 110-Volts Outlet for CX06SC
Figure-2.2 220-Volts Outlet for CX08SC
It is strongly recommended not to use
extension cords with your jointer. Always try
to position your machine close to the power
source so that you do not need to use
extension cords.
In case if you really find it necessary to use
an extension cord, make sure the extension
cord does not exceed 50-feet in length and
the cord is 14-gauge to prevent motor
damage.
Your CX06SC/CX08SC is equipped with a
cord having 3-prongs which fits a 3 prong
grounding receptacle as shown in figure-2.
Do not remove the grounding prong to fit it
into a 2-pronged outlet. Always check with
a qualified electrician if you are in doubt.
WARNING
Improper connection of the equipment-
grounding conductor can result in a risk
of electric shock. Check with a qualified
electrician if you are in doubt as to
whether the outlet is properly grounded.
To Next Page
Loading...
