To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 113.22560 and is the answer not in the manual?
Read manual, learn applications, limitations, and potential hazards.
Use 3-conductor cord and grounding plug for safety.
Keep work area clean, uncluttered, well-lit, and free of children.
Wear appropriate clothing, footwear, and safety goggles.
Refer to page 2 for general power tool safety.
Ensure the tool is properly grounded for electrical safety.
Key points like workpiece support, avoiding wet grinding, and magnesium hazards.
Maintain operator awareness and common sense at all times.
Details horsepower, voltage, amperes, phase, RPM, and belt speed.
Instructions for grounding the tool and using proper outlets.
Steps to install the abrasive belt correctly, noting directional arrows.
Procedure to adjust the belt to run in the center of the wheel.
Move the workpiece across the belt.
Move workpiece across belt, quench if hot.
Instructions for performing work on the inside of the workpiece.
Adjust table, clamp wood, move tool gently.
Remove platen, push workpiece gently, quench if metal.
Upper/lower wheels are permanently lubricated; idlers need light oil.
Addresses motor start issues and electrical protection problems.
Diagnoses power reduction, overheating, and slowdowns.
Identifies causes for frequent opening of fuses or circuit breakers.
Provides guidance on resolving abrasive belt tracking issues.
General