Craftsman 113.226424 - User Manual

SAVE THIS MANUAL
FOR FUTURE
REFERENCE
BELT AN D DISC
SANDER
Serial
Numbe[
Model and serial
number may be found on
the back side of
the base.
You should record both
model and serial number
in a safe place for
future use.
CAUTION:
Read GENERAL and
ADDITIONAL SAFETY
INSTRUCTIONS
_arefuily
!
BELT A
SANDE
DISC
o assembly
• operating
• repair parts
Sold by SEARS, ROEBUCK AND CO., Chicago, tL. 60684 U.S.A.
Part No, SP5137

Summary

General Safety Instructions for Power Tools

Additional Safety Instructions for Belt and Disc Sander

Kickback Precautions

Avoid kickback by sanding on the correct side of the disc/belt.

Personal Protection Equipment

Wear safety goggles, face shield if dusty, ear plugs, and appropriate clothing.

Handling Damaged Parts

Guarding and Entanglement

Motor Specifications and Electrical Requirements

Connecting to Power Supply Outlet

Instructions on how to properly connect the sander to a grounded power source.

Assembly

Mounting Belt and Disc Sander to Workbench

Installing Timing Belt

Installing Sanding Disc Plate

Installing Table Assembly

Squaring Table Assembly

Align the worktable to be 90 degrees square to the disc using a combination square.

Replacing the Sanding Belt, Tensioning and Tracking

Instructions for replacing the belt, adjusting tension, and aligning tracking.

Basic Operation

Bevel Sanding Techniques

Tilt the worktable for bevel sanding at angles from 0 to 45 degrees.

Positioning Belt Table

Surface Sanding on Belt

How to hold and move the workpiece evenly across the sanding belt.

End Sanding on Belt

Sanding Curved Edges

Sand inside curves on the idler pulley and outside curves on the disc.

Sanding Small End Surfaces on Disc

Maintenance

Trouble Shooting

Service and Repair Parts Ordering

How to Order Repair Parts

Craftsman 113.226424 Specifications

General

Brand	Craftsman
Model	113.226424
Category	Sander
Language	English