9
Operating Humidity Max 80% up to 87
o
F (31
o
C)
decreasing linearly to 50% at 104
o
F
(40
o
C)
Storage Humidity <80%
Operating Altitude 7000ft. (2000) meters maximum
Weight 10.7 oz (303g)
Size 9.0” x 3.1” x 2.0” (229 x 80 x 49mm)
Safety For indoor use and in accordance
with the requirements for double
insulation to IEC1010-1 (2001):
EN61010-1 (2001) Overvoltage
Category III 600V and Category II
1000V, Pollution Degree 2.
BATTERY INSTALLATION
WARNING: To avoid electric shock, disconnect the test leads
from any source of voltage before removing the battery cover.
1. Disconnect the test leads from the meter.
2. Remove the rear battery cover by removing the screw using a
Phillips head screwdriver.
3. Insert the battery into battery clips, observing the correct
polarity.
4. Put the battery cover back in place and secure with the screw.
WARNING: To avoid electric shock, do not operate the meter
until the battery cover is in place and fastened securely.
NOTE: If your meter does not work properly, check the battery to
make sure that it is still good and properly inserted.
To Next Page
Loading...
