EasyManua.ls Logo

Craftsman C459-527860 - User Manual

Craftsman C459-527860
56 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
SEARS CANADA, 222 Jarvis St., Toronto, On M5B 2B8
Visit our website: sears.ca
CAUTION: READ
SAFETY RULES AND
INSTRUCTIONS
CAREFULLY BEFORE
OPERATING THIS
EQUIPMENT.
Operator’s Manual
26” TRACK SNOW THROWER
Model No. C459-527860
• SAFETY
• SET-UP
• OPERATION
• MAINTENANCE
• PARTS LIST
10/23/2007
FORM NO. 769-03336
®

Table of Contents

Questions and Answers

  • J
    Joshua RhodesAug 12, 2025
    How to troubleshoot a Craftsman C459-527860 Snow Blower when the engine fails to start?
    • L
      Lori ShortAug 12, 2025
      If your Craftsman Snow Blower engine won't start, there are several potential causes: 1. The choke control might not be in the ON position. To fix this, move the choke control to the ON position. 2. The spark plug wire could be disconnected. Connect the wire to the spark plug. 3. The spark plug might be faulty. Clean, adjust the gap, or replace the spark plug. 4. The fuel tank may be empty or contain stale fuel. Fill the tank with clean, fresh gasoline. 5. The engine might not be primed. Prime the engine as instructed in the Operation Section. 6. The safety key may not be inserted. Insert the key fully into the switch.
  • J
    John GreerAug 17, 2025
    Why does my Craftsman C459-527860 Snow Blower engine run erratically?
    • P
      Philip WrightAug 17, 2025
      If your Craftsman Snow Blower engine is running erratically, consider these potential causes: 1. The engine might be running on CHOKE. Move the choke control to the OFF position. 2. The fuel could be stale. Fill the tank with clean, fresh gasoline. 3. There might be water or dirt in the fuel system. Drain the fuel tank and refill it with fresh fuel. 4. The carburetor might be out of adjustment. Contact your Sears Parts & Repair Center.
  • N
    nicholas79Aug 23, 2025
    What to do if my Craftsman C459-527860 has loss of power?
    • M
      Mark RobinsonAug 23, 2025
      If your Craftsman Snow Blower is losing power, check the following: 1. Ensure the spark plug wire is securely connected and tightened. 2. Check the gas cap vent hole for blockage. Remove any ice and snow from the gas cap, ensuring the vent hole is clear.
  • A
    Alex JonesAug 29, 2025
    Why is my Craftsman C459-527860 not discharging snow?
    • J
      Jonathan MackAug 29, 2025
      If your Craftsman Snow Blower fails to discharge snow, here are a few things to check: 1. The chute assembly might be clogged. Stop the engine immediately, disconnect the spark plug wire, and clean the chute assembly and inside of the auger housing with a clean-out tool or a stick. 2. A foreign object might be lodged in the auger. Stop the engine immediately, disconnect the spark plug wire, and remove the object from the auger with a clean-out tool or a stick. 3. The auger cable may need adjustment. Refer to the Assembly section for instructions on adjusting the auger control cable. 4. The auger belt might be loose or damaged. Replace the auger belt, referring to the Service and Maintenance section. 5. The shear pin(s) might be sheared. Replace them with new shear pin(s).
  • E
    espinozavictoriaSep 5, 2025
    What causes excessive vibration in my Craftsman C459-527860 Snow Blower?
    • C
      Cynthia GlennSep 5, 2025
      If your Craftsman Snow Blower is vibrating excessively, immediately stop the engine and disconnect the spark plug wire. Then, tighten all bolts and nuts. If the vibration continues, have the unit serviced by a Sears Parts & Repair Center.

Craftsman C459-527860 Specifications

General IconGeneral
BrandCraftsman
ModelC459-527860
CategorySnow Blower
LanguageEnglish

Related product manuals