EasyManua.ls Logo

Craftsman C459-52401 - User Manual

Craftsman C459-52401
52 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
CAUTION: Before using this
product, read this manual
and follow all safety rules
and operating instructions.
Operator’s Manual
• SAFETY
• ASSEMBLY
• OPERATION
• MAINTENANCE
• PARTS LIST
®
PRINTED IN U.S.A.
FOR CUSTOMER ASSISTANCE CALL 1-800-668-1238
769-09958
06/10/14
24” Snowthrower
Model No. C459-52401

Table of Contents

Questions and Answers

  • J
    Jodi CastilloAug 12, 2025
    Why won't my Craftsman Snow Blower engine start?
    • G
      Gavin GreenAug 12, 2025
      If your Craftsman Snow Blower engine fails to start, there are several potential causes: * The choke might not be in the CHOKE position; if so, move it to the CHOKE position. * The spark plug wire could be disconnected; connect the wire to the spark plug. * The fuel tank may be empty or contain stale fuel; fill the tank with clean, fresh gasoline. * The engine might not be primed; prime it as instructed in the Operation section. * The spark plug could be faulty; clean, adjust the gap, or replace it. * The key may not be fully inserted into the ignition; insert the key fully into the switch.
  • J
    John LuceroAug 17, 2025
    Why is my Craftsman Snow Blower running rough?
    • J
      Jeffery TannerAug 17, 2025
      If your Craftsman Snow Blower engine is running erratically, with inconsistent RPM (hunting or surging), here are a few things to check: * Ensure the engine isn't running on CHOKE; if it is, move the choke lever to the RUN position. * The fuel may be stale; replace it with clean, fresh gasoline. * There might be water or dirt in the fuel system; drain the fuel tank and refill with fresh fuel. * The carburetor might be out of adjustment or the engine over-governed; in these cases, contact an authorized Service Center.
  • M
    Mary BallAug 23, 2025
    What to do if Craftsman C459-52401 Snow Blower loses power?
    • C
      collinskylieAug 23, 2025
      If you experience a loss of power with your Craftsman Snow Blower, check the following: * Make sure the spark plug wire is securely connected and tightened. * Ensure the gas cap vent hole isn't plugged; remove any ice and snow, and make sure the vent hole is clear.
  • T
    Tamara ChenAug 29, 2025
    Why won't my Craftsman C459-52401 Snow Blower throw snow?
    • H
      Haley SmithAug 30, 2025
      If your Craftsman Snow Blower is not discharging snow, consider these possible causes: * The chute assembly may be clogged; stop the engine immediately, disconnect the spark plug wire, and clean the chute assembly and inside of the auger housing using a clean-out tool or a stick. * A foreign object might be lodged in the auger; stop the engine immediately, disconnect the spark plug wire, and remove the object from the auger using a clean-out tool or a stick. * The auger control cable may need adjustment; refer to the Auger Control Test. * The auger belt could be loose or damaged; refer to the Maintenance & Adjustments section. * The shear pin(s) may have sheared; replace them with new shear pin(s).
  • O
    owensandreaSep 4, 2025
    How to fix excessive vibration on Craftsman C459-52401?
    • A
      Andrew SimonSep 4, 2025
      If your Craftsman Snow Blower is vibrating excessively, immediately stop the engine and disconnect the spark plug wire. Tighten all bolts and nuts. If the vibration continues, have the unit serviced by an authorized Service Center.

Craftsman C459-52401 Specifications

General IconGeneral
BrandCraftsman
ModelC459-52401
CategorySnow Blower
LanguageEnglish

Related product manuals