Can, Cold Food, and Frozen Food Module Setup and Operator’s Guide
4840053 Page 3 February, 2000
Selection ID numbers are printed on clear plastic sheets. You will find these in the plastic bag that
contained this manual. You will need to separate them along the scored lines between the selections.
BE CAREFUL when doing this, because it is easy to split the labels. Use the "E" and "F" selections
for the can module.
Installing Selection ID Numbers:
1. Make sure the price rolls have been installed.
2. Press together the two long edges of the selection ID label.
3. Snap the selection ID label into position on the front of the tray as shown. See the bottom figure
on the next pate for the position of each of the selections.
4. Install Selection ID Labels
SELECTION
IDENTIFICATION LABEL
CENTS
PRICE ROLL
DOLLAR
PRICE ROLL
SELECTION
IDENTIFICATION
157P0059
To Next Page
Loading...
