3
SPECIFICATIONS:
MODEL: BAF-6 (091550)
LOCATION: This BAF-6 is designed for wet wells, tanks, or lift stations where it is necessary to
remove a pump from service and reinstall the pump without maintenance personnel
entering the pit to unbolt the pump fl anges.
STATIONARY ELBOW: Cast iron, ASTM A48, Class 30.
MOVABLE FITTING: Cast iron, ASTM A48, Class 30.
GUIDE RAIL CAP:
Bracket: 304 stainless steel
Plugs: Ductile iron, ASTM A536-84.
HARDWARE: 300 series stainless steel.
O-RINGS: BUNA-N, 70 +/- 5 Duro.
GASKETS: Rubber
PAINT: Air Dry Enamel
MODEL: BAF-E6 (091551)
LOCATION: This BAF-6 is designed for wet wells, tanks, or lift stations classifi ed as Hazardous
location Class 1, Group D, Division 1 and/or non-hazardous locations, where it is
necessary to remove a pump from service and reinstall the pump without
maintenance personnel entering the pit to unbolt the pump fl anges.
STATIONARY ELBOW: Cast iron, ASTM A48, Class 30.
MOVABLE FITTING: Bronze (81-3-7-9).
GUIDE RAIL CAP:
Bracket: 304 Stainless steel
Plugs: Ductile iron, ASTM A536-84.
HARDWARE: 300 Series stainless steel.
O-RINGS: Buna-N, 70 +/- 5 Duro.
GASKETS: Rubber
PAINT: Air Dry Enamel
OPTIONAL:
INTERMEDIATE SUPPORT:
Bracket: 304 Stainless Steel.
Plugs: Cast iron, ASTM A48, Class 30.
Hardware: 300 Series Stainless Steel.
O-Rings: Buna-N, 70 +/- 5 Duro.
LIFTING CHAIN: 5/16, or 3/8 in., proof coil chain, hot galvanized.
Testing is performed with
water, specifi c gravity of
1.0 @ 68° F, other fl uids
may vary performance
To Next Page