THE VENDER MUST BE PROPERLY LOCATED AND LEVELED. IF THE MACHINE
WILL BE SUBJECT TO USER MISUSE OR VANDALISM IT IS RECOMMENDED THAT
THE VENDER BE SECURED TO THE FLOOR OR WALL AS DESCRIBED IN CRANE
MERCHANDISING SYSTEMS TECHNICAL BULLETIN 344 TO MINIMIZE THE RISK OF
INJURY OR DEATH FROM TIPPING. CALL THE CRANE MERCHANDISING SYSTEMS
TECHNICAL SERVICE DEPARTMENT OR YOUR CRANE MERCHANDISING SYSTEMS
REPRESENTATIVE FOR ASSISTANCE.
LOCATE THE VENDER
Do not block the rear of the Vender. Maintain a minimum of 4 inches (10 cm) from the wall to ensure adequate
airflow through the condenser and compressor. At the rear of the Vender, make sure nothing obstructs the air
exhaust at the back of the Machine.
WARNING
TO AVOID THE POSSIBILITY OF A FIRE HAZARD, DO NOT STORE ANYTHING OR
ALLOW DEBRIS OF ANY KIND TO ACCUMULATE IN THE BOTTOM OF THE DOOR,
IN THE BOTTOM OF THE SERVICE AREA, IN AND AROUND THE REFRIGERATION
COMPARTMENT OF THE CABINET, OR IN FRONT OF THE EVAPORATOR AND
CONDENSER COILS.
INSTALLING PRICE LABELS
Pricing labels when ordered will be included with additional parts, labels, and information placed in Tray “B” during
shipment. Remove the pricing label sheets from the Tray and gently remove the label corresponding to the vend
price of each selection by tearing at the perforation. The label is installed at the top of the front knuckle. Once
installed, push the label firmly against the front of the knuckle. This will insure the label is locked in place.
INSTALLING PRODUCT ID CARDS
To assist with consistent loading, product ID cards can be installed in the product pusher to designate to the route
driver which product the column is set for. To install the flavor card, simply detach it from the sheet at the
perforation and slide it into the slots in the product pusher. Contact your graphics supplier to purchase as needed.
COIN CHANGERS & OTHER ACCESSORIES
The Vender can have an MDB Coin Changer installed and can have an MDB Bill Acceptor installed as well. Note:
BevMax 4 5800-4/3800-4 will work with an MDB Bill Acceptor only. If the MDB Coin Changer and other MDB
accessories are not factory installed, refer to the instructions received from the manufacturer of the MDB Coin
Changer and other MDB accessories for proper set-up and installation.
The Vender will support the following Domestic MDB Coin Changers:
All available CPI/MEI MDB
All available Conlux MDB
All available NRI MDB
All available Coinco MDB
To Next Page
Loading...
Need help?
General
