Page 31 of 62
General Maintenance
The most important facets of proper care and maintenance of your Machine are the electrical power supplied,
leveling, and cleanliness of the Machine.
POWER
Domestically the Machine must be connected to a dedicated 120 VAC, 15 Amp circuit (U.S. and Canada). Refer to
the cabinet serial number plate to determine the correct voltage and frequency for the Machine.
CAUTION:
REMOVE POWER TO THE AC DISTRIBUTION BOX BEFORE CLEANING OR WHEN ANY ELECTRICAL
COMPONENTS ARE CONNECTED / DISCONNECTED FOR TESTING OR REPLACEMENT.
Periodically inspect the Power Supply Cord for damage. If the Cord or Cord Plug is
worn or damaged, it must be replaced with a Power Supply Cord of the same type,
size and specification as originally provided with the Machine.
DO NOT USE THE VENDING MACHINE UNTIL THE WORN OR DAMAGED POWER SUPPLY
CORD IS REPLACED.
The Ground Fault Circuit Interrupter (GFCI) for Domestic Venders must be tested frequently and before each use
in accordance with the instructions provided on the GFCI device. IF THE GFCI DOES NOT PASS THE TEST, DO
NOT USE THE MACHINE. Unplug the Power Supply Cord from the receptacle and call the Crane Merchandising
Systems Technical Support Group for assistance at 1-803-266-5001.
CAUTION:
REMOVE POWER TO THE AC DISTRIBUTION BOX BEFORE CLEANING OR WHEN ANY ELECTRICAL COMPONENTS
ARE CONNECTED / DISCONNECTED FOR TESTING OR REPLACEMENT.
CLEANING
DO NOT USE A WATER JET OR NOZZLE TO CLEAN THE VENDER.
GLASS DOOR
The Display glass should be cleaned inside and out with paper towels and glass or non-abrasive all-purpose
cleaner. The gasket around the product door should be wiped down using warm water, any mild general
purpose, non-abrasive cleaner and a soft towel. Never lubricate the gasket and always check for cracking or
deformities which may cause leaks. Replace if necessary.
TRAYS / TRAY INSERTS
The Trays and Tray inserts should be cleaned periodically using warm water and a mild general purpose, non-
abrasive cleaner. Care should be taken to ensure debris does not enter the gear box assemblies. DO NOT
USE SOLVENTS OR ABRASIVE MATERIALS TO CLEAN ANY PORTION OF THE TRAY.
To Next Page
Loading...
Need help?
General
