Page 55 of 101
CABINET OFFSETS
This Menu allows you to check and set the Hook
Swipe position as well as change the height of
travel for Picker Cup.
• Auto Calibrate the Hook Offset.
• Move to the swipe position set or changed
in the Hook Offset menu.
• Manually set the Hook Offset Note: if you
are manually setting the Hook Offset make
sure you turn off Auto Hook Offset,
otherwise the hook swipe number will be
reset on the first vend every time the door is
closed.
• Change the Shelf Offset (how high the picker cup goes).
Pressing Auto Calibrate Hook Offset will cause the delivery cup to move to
the swipe position, and automatically set the swipe position.
Pressing Move to Swipe Position will move the delivery cup to the swipe
position based on the Hook Offset number set in the Hook Offset Menu.
Note: The Motor Power Interrupt Switch (left switch in bracket) must be
engaged and the Switch Lock slid forwards for power to be applied. This will
allow the Delivery Cup Assembly to move to the swipe location as if it were
making a delivery.
Hook Offset – This Menu allows you to manually set the hook offset
(distance from the wall). The target swipe distance is about the thickness of
two quarters from the wall. Since 3310 equals one inch, this setting is usually
changed in increments of 200, 100 and maybe 50 for a minuet change. To
change the Hook Offset setting touch the Hook Offset Menu Bar and a
numeric screen will appear allowing you to enter a new offset number.
Choose Accept to save.
Note: When manually entering a Hook Offset number Enable autocal hook
offset must be off.
Note: The Motor Power Interrupt Switch (left switch in bracket) must be
engaged and the Switch Lock slid forwards for power to be applied, this will
allow the Delivery Cup to move to the swipe location as if it were making a
delivery.
To Next Page
Loading...
