Page 56 of 101
Shelf Offset – This Menu allows you to change the height of the picker cup.
To test changes you will need to go to the Platform Movement menu item in
the test Menu.
MODEL NUMBER
This Menu allows you to choose the machine Model Number:
• BevMAX 6 - 3800 = 7 selection across the shelves.
• BevMAX 6 - 5800 = 9 selection across the shelves.
• Renaissance - 3800r = 7 selection across the shelves.
• Renaissance - 5800r = 9 selection across the shelves.
Touch the Model Number Menu Bar.
ENCODER RESOLUTION
Pressing the Encoder Resolution icon will not change setting. This screen is
view only and cannot be changed. It is for information purposes only.
3310 is the number of Encoder counts per inch so when making changes to
the X or Y motor this is a reference. Since 3310 = 1” then 331 = a tenth of an
inch.
ENABLE AUTOCAL HOOK OFFSET
This feature is optional and may be turned off. (note: the default is on).
Note: if set to Off you can manually set the hook offset in the System
Settings/Cabinet Offsets.
On the first vend after each door closure and on the first vend after a power
cycle the Media Atlas H Board software will measure and set the hook offset.
This is considered a “calibration vend”.
On a calibration vend, rather than stop at the hook offset setting, the cup will
continue to move to the right until it stops moving by hitting the wall. Then a
mathematical formula is used to calculate the hook offset based on the
position of the cup when it stops moving. The VMC will then save this newly
calculated hook offset.
Touch Enable autocal hook offset Menu Bar to toggle On/Off.
To Next Page
Loading...
