5.6 Button 6 - Test Vend
This button enables the operator to vend a drink from the machine to ensure correct operation
after cleaning or maintenance.
1. When the button is pressed a drink can be selected from the menu displayed.
2. Exit from the Test menu by pressing the Up one level key-pad.
5.7 Button 7 - Cup Test
This button enables the operator to test the operation of the cup drop unit. When the button is
pressed the cup drop motor is operated and a cup is dispensed.
5.8 Button 8 - Park Head
When this button is pressed, the dispense head moves to its fully extended position and stops.
Press the button again to return it to its homed position.
5.9 Button 9 - Boiler Fill (Espresso Machines Only)
When pressed, the machine pumps a measured amount of water through the system
(approximately 400ml). This button should be used to purge any water left in the system after
the machine has been moved or shut down for any length of time.
5.10 Button 10 - Machine Cool Down (Espresso Machines Only)
Important! This button enables an engineer to work safely on the water system and
should not be used by the operator.
5.11 Button 11 - CoEx® Tablet Clean (Espresso Machines Only)
When pressed, initiates the CoEx® brewer tablet cleaning routine. Crane
Merchandising Systems recommends that this brewer cleaning routine should be carried weekly.
5.12 Button 12 - Reset Waste Counter (Fresh Brew & Espresso Machines)
When the waste container is emptied the counter must be reset.
When pressed the counter is reset, it is confirmed by pressing the OK button on the front screen
Note: Only relevant if the feature is enabled in the program (it is disabled by default)
5.13 Button 13 - Syrup Prime (Still/Carbonated Machines Only)
This button enables the operator to prime the syrup selections.
5.14 Button 14 - Not used
5.15 Button 15 - Start
When weighing ingredients within service mode this button has the same functions as START on
the drink selection key-pads.
5.16 Button 16 - Not used
To Next Page
Loading...
