Creality HALOT-ONE PLUS User Manual

10
8. Release Film (FEP) Replacement
a. First, remove the 14 screws at the bottom of thetray and take
out the broken release film (FEP).
b. Then place the release film between the two steel frames.
c. Finally,put the assembled steel frame back into the tray and
tighten 14 screws.
d. The installed release film is as show.

Creality HALOT-ONE PLUS Specifications

General

Brand	Creality
Model	HALOT-ONE PLUS
Category	3D Printers
Language	English