Creality HALOT-ONE - Level Platform Part 1

07
7. Level Platform 调平平台 1
Note: The printint platform has been leveled at the factory. If it needs leveling due to transportation or other reasons, please follow the steps
below to adjust the printing platform.（ Please bring flat A4 paper by yourself ）
注意： 打印平台出厂时已调平，若因运输或其他原因需要调平，可以进行以上步骤进行打印平台调平。（请用户自备平整A4纸张）
1. To calibrate the printing platform, first raise the platform, loosen the
fixing screws on the left and right sides of the material trough, and
take out the material trough;
进行打印平台的校准，首先上升平台，拧松料槽左右两侧料盘固定螺丝，
将料槽取出 ;
2. Loosen the four screws on the connect-
ing plate of prototyping platform, attach
A4 paper tightly to the print screen, press
Settings → Z Axis Motion → Levelling（Refer
to operating steps of levelling platform 2
for operation.）, to check whether the
platform fits evenly with the paper.
松开成型平台板连接板的四颗螺丝，将A4纸贴
紧打印屏，按设置→Z轴运动→调平（参照调平
平台2步骤作业），检查平台是否与纸张均匀贴
3. After confirming that A4 paper fits
evenly with the platform, screw up the
four screws of the platform.
确认A4纸均匀贴合后，锁紧平台的四颗螺
丝。