Need help?Do you have a question about the Creality 3dpRINTmILL and is the answer not in the manual?
Instructions for installing and launching the necessary slicing software.
Steps to configure the software with printer and print settings.
Instructions for installing and launching the necessary slicing software.
Steps to configure the software with printer and print settings.
General| Layer Resolution | 0.1-0.4 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Heated Bed | Yes |
| Bed Temperature | Up to 100°C |
| Nozzle Temperature | Up to 260°C |
| Category | 3D Printer |
| Connectivity | USB, SD Card |
| Supported Materials | PLA, ABS, TPU |
To Next Page