D-2 Troubleshooting
Problems With
Sound
There is unexpected excessive environmental sound or effects when an audio file is played.
The last selected preset is an inappropriate environment for the current audio file.
To switch to an appropriate environment:
1. Open the Environmental Audio control applet in AudioHQ.
2. In the Environment list, select “No effects” or an appropriate environment.
No sound from the headphones.
Check the following:
❑ The headphones are connected to the Line Out jack.
❑ Under the Speaker view in the Main deck of Surround Mixer, make sure that the Speaker
selected is “Headphones”.
In a 4-speaker configuration, there is no sound from the rear speakers.
Check the following:
❑ The rear speakers are connected to the audio card’s Rear Out jack.
❑ If you are playing sound from one of these sources:
• CD Audio
• Line In
•TAD
• Auxiliary (AUX)
• Microphone
To solve the problem:
1. In Surround Mixer’s Mixer deck, make sure the radio button of the source being played is
selected, that is, enabled.
2. Select the same source as the record source.
If your record source is “What U
Hear”, then at any one time, you
can only select one of the five
sources and mute the others.
Therefore, you can get sound
from the rear speakers only from
the selected source.
To Next Page
Loading...
