Crem EX2 - Boiler Pressure and Temperature Information

17
Original instructions.
· Drain connection checklist
1. Connect one end of the exible drain
tube to the drain cup outlet by inserting
it through the access hole in the panel
mounted in the bottom of the chassis.
(It is located under the drip tray and grill.
Contact a service technician to do this task
you are unsure how to access this area of
the machine.)
2. Connect the other end of the drain tube to
the domestic plumbing drainage system in
the service area.
3. Replace/reinstall the drip tray and grill.
Flexible drain tube
Drain cup
adapter
Pro Tip:
Ensure that the drainage tube is not twisted and that it is below
the level of the drain cup to prevent trapping water and other
residue in the tube which could mold or produce bad smells.
INSTALLATION AND START UP
Pro Tip:
Signicantly exceeding this operating range will result in excessive steam, high
energy usage, and milk scorching. Setting the temperature too low will resulting
poor coee extraction, slow group boiler heating, and low/no steam.
Boiler pressure is directly controlled by water temperature. The steam boiler’s optimal temperature
operating range is from 116-120
o
C for milk steaming and brewing results.
Relationship between boiler pressure and temperature
Optimal operating pressure and temperature
· Boiler pressure and temperature information
Boiler drain tap
WARNING!
Never open the boiler drainage tap while the machine is in
operation! Close position = Right side
The pressurised hot water could cause scalding or serious injury.
Emptying the boiler must be performed by qualied personnel.
0.7
110
115
120
125
0.8 0.9
1
1.1 1.2
o
C
BAR