Crem EX2 - Operation; Inserting the Portafilter; Espresso Brewing

20
Original instructions.
OPERATION
· Inserting the portalter in the group
Group gasket is
worn out and
needs to be
replaced.
Align the portalter's
two anges with the
two slots in the group
housing.
Insert the portalter and rotate it
counterclockwise until the handle
is approximately perpendicular to
the face of the coee machine.
Installed
correctly.
· Espresso brewing
1. Unlock and remove the portalter from the group head.
2. Fill the lter basket with espresso-grind coee (approx. 7g for single or 14g for a double espresso).
3. Compact the coee.
4. Insert the lled portalter into the group head and lock it into the correct position.
5. Place the cup(s) under the portalter.
6. Select the desired option from the drink button to begin brewing.
WARNING!
Never try to open the portalter while the
machine is in operation! The pressurised hot
water could cause scalding or serious injury.
After dispensing has nished, wait at least 3
seconds before removing the portalter.
Pro Tip:
When not in use store the portalter
inserted in the group to keep it warm.
This is important to maintain optimal
brewing temperature while the espresso
is dispensing.
· Dispensing hot water
WARNING!
Never place hands and ngers directly under the hot water outlet during
dispensing to avoid scalding or serious burns.
1. Place a pitcher (or other heat resistant vessel) under the hot water outlet.
2. [Automatic]: Press the desired hot water button to begin dispensing.
[Manual]: Rotate the knob counter clock wise, to begin dispensing
3. [Automatic]: Hot water dispensing will stop automatically after the programmed
dispensing time is reached, or press the button again to stop it manually any time before
it nishes.
[Manual]: Rotate the knob clock wise, to stop dispensing hot water