Crem EX2 - Initial Starting Procedure

19
Original instructions.
Do not place wet cups directly on the cup shelf.
Always thoroughly dry any cups before storing
them on the warming shelf.
WARNING!
Allowing water to drip into the
machine can cause mechanical
and electrical damage.
· Machine handling tips
INSTALLATION AND START UP
Before using the machine be sure to:
1. Ensure the machine’s domestic water supply is opened at the tap.
2. Turn on the main power switch.
3. The machine will rell the boiler automatically before heat up process begins.
4. Conrm that the heating lamp is illuminated while the boiler is heating, run a drink cycle
through each group to bleed air out of the brewing system, and wait a few minutes for the
boiler to heat up.
5. Open the steam knobs/taps to ensure they are working.
6. When the boiler reaches the working pressure / temperature, the heating lamp will turn o.
Wait extra 10 minutes to allow all hydraulic components to reach and stabilize into correct
temperature
The machine is now ready to use.
Note:
Remove all protective lm during installation before powering the machine ON for the rst
time. This will prevent the lm melting/becoming stuck due to high temperature when the
machine is heating up.
· Initial starting procedure
i