27
10. EMC(Electromagnetic Compatibility）
Special precautions for electromagnetic compatibility are required for this equipment. And
must be installed and used in accordance with the electromagnetic compatibility information
specified in this specification.
Portable and mobile radio frequency communications equipment may have an impact on
the device
You must use the cable and accessories provided by this equipment. Cable information is as
follows:
In addition the cable to being sold as spare parts of internal components, use of
non-specified accessories and cables may result in reduced immunity to equipment or systems.
The equipment or system should not be used or stacked with other equipment. If it is
necessary to be close or stacked use, it should be verified that it can normally operate in its
configuration.
Basic performance for normal operation:
The device can run normally during the test.
Guidance and manufacturer's declaration - electromagnetic emissions
The device is intended for use in the electromagnetic environment specified below. The customer
or the user of the device should assure that it is used in such an environment.
Electromagnetic environment - guidance
The device uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are
not likely to cause any interference in nearby electronic
equipment.
The equipment is suitable for use in all facilities,
including household directly connected to the public
low-voltage power supply network that supplies buildings
used for domestic purposes.
Harmonic emissions
GB 17625.1
Voltage fluctuations/
Flicker
GB 17625.2
To Next Page
Loading...