Product Manual — Doc.
9323C
IV-CAMA3-20-N-W-1B, IV-CAMA3-20-N-SLVR-1B, IV-CAMA3-20-W-1B, and IV-CAMA3-20-SLVR-
1B • 42
2. If displays and projectors overlap the entire Tracking Zone, the camera can lose track of the
presenter if it is unable to lock onto a presenter's face or detect motion.
Set Preset 0 and 1
After the camera's tracking properties are set, set presets 0 and 1. These two presets serve as the
camera's reference for how it frames a presenter and the shot it defaults to when no one is presenting.
NOTES:
l
Do not overwrite presets 0 and 1. They serve as the main reference point to determine the
camera’s tracking properties.
l
If the camera will be controlled using a 3rd party control system and presets need to recall
different shots, use presets 2 and higher.
Preset 0 - The Home Position
Preset 0 is the shot that the camera will revert to when no presenter is detected or tracked. This preset
should be set to a view of the entire presentation area.
Under some circumstances, it may not be preferential for the camera to zoom all the way out only to
zoom in again once a presenter or speaker enters - for example when a podium shot is preferred. In this
case, a tighter shot should be set for Preset 0.
To set Preset 0:
1. Navigate to the Main View tab.
2. To move the camera, use the arrow buttons and Zoom + / - in the PTZ Lens section.
To Next Page
Loading...