Crestron AV2 & PRO2 2-Series Integrated Dual Bus Control System
Configure AV2 and PRO2
DEVICE SYMBOL DROP ADDITIONAL
LIBRARY REQUIRED WHERE SETUP
Control
Systems
AV2 System
Views
Configure the built-in slots.
AV2 With
Card Cage
System
Views
Configure the available and built-in slots.
PRO2 System
Views
Configure the available and built-in slots.
Plug-in
Control
Cards [Cards
(2-Series Y
Bus) or
Cards (CNX
Series
]*
Depends
upon system
requirements.
Empty C2Y
Card Slots
(slots 1
through 3)
Depends upon the type of card dropped
into the slot. Refer to the documentation
supplied with the specific card for
additional setup information.
Serial
Drivers
(General)
C2 COM Two-
way serial
driver
C2I-COM6
(Slot 4)
As devices are dropped onto slot 4, they
are assigned to port A through port F, in
sequence by default.
COMMUNICATION PARAMETERS - In
the System Tree, scroll down to Slot 4:
C2I-COM6 within the control system and
expand to display the individual ports.
Single-click on the desired port, then
ri
ht-mouse click and select Confi
ure.
Select the SERIAL SETTINGS tab to
display a window that allows for the
assignment of communication
arameters.
REASSIGN DEVICES TO A PORT
(OPTIONAL) - In the System Tree,
double-click on the device that needs to
be reassigned to open the "Device
Settings" window. Select the PORT
ASSIGNMENT tab and scroll to the
desired port address.
(Alternatively, single-click then right
mouse-click on device that needs to be
reassigned. Select Configure to open
"Device Settings" window.)
* Only applies to AV2 With Card Cage and PRO2.
Operations Guide - DOC. 5957 Integrated Dual Bus Control System: PRO2 & AV2 • 31
To Next Page
Loading...
