Crestron AV2 & PRO2 2-Series Integrated Dual Bus Control System
List of Acceptable Commands for the 2-Series Integrated Dual Bus Control System
COMMAND DESCRIPTION
ADDMASTER Add an entry to IP table
AUTONEGOT Set auto negotiation for Ethernet device
BROADCAST Enable/disable the broadcasting of error messages
BYE Close user session
CARDS Display cards detected in system
CD Change the file directory
CIPPORT Specify the port for the CIP interface
CLEARERR Clears the current error log
COMPACT Remove invalid files from system
CNETID Set the Cresnet ID of the panel
CTPPORT Specify the port for the CTP console
DEFROUTER Set default router
DELETE Delete file(s)
DIR Display files in directory
ECHO Enable/disable character echoing
EEPROM Displays the parameters stored in EEPROM
ERRLOG Prints the current error log
ESTATUS Displays the status and parameters for the Ethernet card
ETHERNET Enable/disable Ethernet
ETHERTEST Perform diagnostic test on the Ethernet card
FPPASSWORD Set front panel password
FREE Show available file space
HEAPFREE Show available heap space
HELP Display help screens
INFO Print software capabilities
INITIALIZE Clear file system
IPADDRESS Set IP address
IPMASK Set IP subnet mask
IPTABLE Display IP table
MESSAGE Display a message on front panel screen
PASSWORD Set console password
PING Perform IP ping test on remote node
RAMFREE Show available file space in the ram file system
REBOOT Perform system reboot
REMMASTER Remove an entry from IP table
REPORTCRESNET Show all devices on the main Cresnet leg
RESTORE Restore factory defaults
RTSCTS Set/clear hardware handshaking
SAVE Save system parameters
SELFTEST Initiate the self test procedure
SERIAL Set serial communication parameters
SETSIGNAL Set the state of a signal in the program
SHOWHW Display hardware configuration
SYSTEM Xmodem download new firmware
TIMEDATE Set the time and date
TYPE Display file contents
UPLOAD Load file into cresnet device
VERSION Print version to console
WEBSERVER Enable/disable Webserver
WEBINIT Initialize Webserver default file
WEBPORT Specify the port for the Webserver
XGETFILE Use Xmodem to retrieve file from panel
XONXOFF Set/clear software handshaking
XPUTFILE Use Xmodem to transfer file to ROM
Operations Guide - DOC. 5957 Integrated Dual Bus Control System: PRO2 & AV2 • 39
To Next Page
Loading...
