Crestron DigitalMedia 3-Series - Place on a Flat Surface

Reduced Airflow: Installation of the equipment in a rack should be such
that the amount of airflow required for safe operation of the equipment
is not compromised.
Mechanical Loading: Mounting of the equipment in the rack should be
such that a hazardous condition is not achieved due to uneven mechanical
loading.
Circuit Overloading: Consideration should be given to the connection of
the equipment to the supply circuit and the effect that overloading of the
circuits might have on overcurrent protection and supply wiring.
Appropriate consideration of equipment nameplate ratings should be
used when addressing this concern.
Reliable Earthing: Reliable earthing of rack-mounted equipment should be
maintained. Particular attention should be given to supply connections
other than direct connections to the branch circuit (e.g., use of power
strips).
Place on a Flat Surface
Attach the included feet near the corners on the underside of the control
system before placing it onto a flat surface or stacking it with other
equipment.
2
DMPS3-200-C, DMPS3-300-C, & DMPS3-300-C-AEC
QuickStart
3-Series® DigitalMedia™ Presentation Systems