Crestron Horizon HZ-THSTAT - Page 5

8. Using the mounting screws (included), screw the backplate to the box
or bracket. Do not overtighten.
NOTE: Use the included washers to prevent overtightening when
installing to a new work electrical box.
9. Wire the backplate. Refer to the Connect the Device section.
10. Plug the wire hole on the back of the thermostat with the included
foam insulation. Refer to the Wiring Diagrams section.
11. Attach the thermostat to the backplate.
5
HZ-THSTAT
QuickStart
Horizon® Wireless Thermostat