Isys
®
5.7” Wall Mount Touchpanel Crestron TPS-6L
Connectors, Controls & Indicators (Continued)
#
CONNECTORS
1
,
CONTROLS &
INDICATORS
DESCRIPTION
9
NTSC/PAL
INPUT
(1) 5-pin 3.5mm detachable terminal block;
Balanced (CAT5) or unbalanced (coaxial)
composite video inputs;
Formats: NTSC 480i or PAL 576i;
Input impedance: 100 Ω balanced,
75 Ω unbalanced;
Input level: 1 V
p-p
nominal;
Balanced input normally connects to a
Crestron CAT5 balanced video source via
CresCAT cable
3
;
Maximum CAT5 cable length: 750 feet
10
SPEAKER OPTION
(1) Six-pin (2x3) rectangular connector;
Connects to optional SPK-6L speaker kit
(sold separately).
1. Interface connectors for NET, MIC OUT, AUDIO INPUT, and NTSC/PAL INPUT ports are
provided with the unit.
2. To access the reset button, remove the bezel and then use a narrow blunt instrument such as the end of
a ballpoint pen to press the button.
3. For details on CAT5 wiring, refer to the latest version of the CAT5 Reference Guide (Doc. 6137),
which is available for download from the Crestron website (www.crestron.com/manuals
).
CAUTION: Do not attempt to press the reset button by inserting a paperclip or
similar device through the small hole in the bezel. This could cause physical damage
to the microphone or the light sensor, or a short circuit on the printed circuit board
located in that area. Remove bezel to access the reset button.
10 • Isys
®
5.7” Wall Mount Touchpanel: TPS-6L Operations & Installation Guide - DOC. 6630A
To Next Page
Loading...
Need help?
General
