2.13
Pinto BT-POM 1212 - Revision 5
Section 2 Hook-up
3a Electric/Hydraulic
Valves
If your sprayer is fitted with wing-lift,
and/or independent outer wing fold, the
hydraulic system on the sprayer consists
of electric over hydraulic valves to enable
all functions to be operated from one set
of hydraulic remotes.
1 Hook up the hydraulic hoses to the
tractor remotes.
2 Install the electric/hydraulic control
console in the cab in a suitable
location.
3 Ensure the power leads are
connected to the battery terminals
(See page 2.18 "auxilary power
leads").
4 Connect black trailer plugs at rear of
tractor (see pictures above & below).
Once the boom & lift hydraulic
system is hooked up correctly,
test the boom functions with the
tractor running. Ensure your working/
testing area is clear of bystanders.
If your sprayer is fi tted with a
hydraulic pump drive, connect the
hydraulic hoses to the tractor
remotes.
Please read the following page to ensure you
know if your tractor has open or closed centre
hydraulics.
This is VERY IMPORTANT to ensure your pump
drive works correctly.
NOTE
Hydraulic drive pump.
Electric/hydraulic control console.
Push the electric/hydraulic connectors together until
they lock together.
Electric/hydraulic valves. Hose marked with cable-tie is for the PRESSURE line.
3b Hydraulic Pump Drive
Set-up
1 If your pump is fi tted with a hydraulic
pump-drive, connect the hydraulic
pressure and return lines to your
tractor remote.
Connect the electric/hydraulic console cables at rear of
the tractor.
Ensure the marked hydraulic line is designated
as your pressure line (see pic above)
NOTE
Instruction tag attached to the hydraulic drive pump.
To Next Page
Loading...