Croplands Pinto 2000 - Page 46

3.3
Pinto BT-POM 1212 - Revision 5
Section 3
(1) Remove the end cap of the Fill Inlet (2000 litre).
(2) Turn the Bottom Fill Inlet Valve to the main tank.
(1) Remove the end cap of the Fill Inlet (3000 litre).
(2) Turn the Fill Selector Valve to "Flushing tank".
(1) Remove the cap of the Fill Inlet (2000 litre).
(2) Turn the Bottom Fill Inlet Valve to the Flush tank.
(1) Unscrew the fl ush tank lid for top-fi lling.
Filling
2 Flush Tank
Use clean, fresh water (preferably
rainwater) in the 200 litre fl ush tank.
Always fill the flushing tank before
spraying.
Top Filling
To top-fi ll the fl ush tank:
1 Unscrew the fl ush tank lid.
2 Fill the fl ush tank.
3 Replace the fl ush tank lid.
Bottom-Fillng
Bottom-fi lling requires a pressured water
source.
• 3000 Litre
To Bottom-fi ll the Flush tank:
1 Remove the end cap from the fi ll inlet
& connect the fi lling hose.
2 Turn the Fill Selector Valve to the
"Flushing tank".
3 Fill the Flush tank with the amount of
water required.
4 Disconnect fi lling hose and replace
the end cap.
• 2000 Litre
The bottom-fi ll facility requires a pressured
water source and is used to fi ll both the
main tank and fl ushing tank.
To bottom-fi ll the main tank:
1 Remove the end cap from the fi ll inlet
& connect the fi lling hose.
2 Turn the Bottom Fill Inlet Valve to the
main tank.
3 Fill the main tank with the amount of
water required.
4 Disconnect fi lling hose and replace
the end cap.
• 2000 Litre
To Bottom-fi ll the Flush tank:
1 Remove the end cap from the fi ll inlet
& connect the fi lling hose.
2 Turn the Bottom Fill Inlet Valve to the
Flush tank.
3 Fill the Flush tank with the amount of
water required.
4 Disconnect fi lling hose and replace
the end cap.