15
How to Control Outputs and Devices
The keypad enables control of external devices, such as an air-conditioner or heater. To
activate or halt a device, press <CONTROL> , Program and System LED’s lights up
steady , press the number of the device , up to 8 different devices can be controlled via
the keypad ,then press <ENTER> to activate or deactivate the selected device. To check
what outputs are ON simply press the <CONTROL> key , LED’s corresponding to device
ON lights up .Press <ENTER> to return to normal mode.
How to Get into to User Program/Client Mode
There are 2 levels of program mode, CLIENT mode and INSTALLER mode. Normally the
installer will give you access to the CLIENT mode so you can add, delete, or change the
user codes. If you request it your installer can provide you with access to the INSTALLER
mode as well. To get into CLIENT mode provided the system is NOT armed Press
<PROGRAM> enter Master code and <ENTER>. The Program indicator lights up to
indicate that the system is in User programming mode.
If you get a single long beep at this point and the Program LED doesn’t turn on, it means
your code cannot access Program mode.
• How to exit program mode
To exit out of program mode press <PROGRAM> and <ENTER>. The Program indicator
goes off to indicate that the system is not in User programming mode.
How to Change or Add Codes
About Master code and User code
The factory default master code (123) is intended as a preliminary control of the alarm
system. After PowerWave is installed and put into service, the code can be changed to
any code known to the Master user. The Master user can define up to 9 user codes. To
limit access rights, the holder of the Master code can ask the installer to define several
User profiles.
Access rights are listed below:
- User code has Area A and/or B permission
- User code can arm and/or disarm arm an area
- User code can arm and/or disarm arm an area in Stay mode
- User code can change its code
- User code can change user’s code
- User code can change dialler telephone numbers
- User code can alter the real time clock
To Next Page
Loading...
