9
Operation
How to Arm the System before Exit
• Preparing the System for Arming
Verify that the green <Ready Byp> indicator is lit .This indicator is lit only when all zones
are closed (all doors, exits and windows are closed and motion in the protected area is
restricted or bypassed) , the system is ready to be armed. If the green <Ready Byp >
indicator is not illuminated, the zone LED 1 to 8 is lit displays the open zones .
Close open zones, or bypass them. Bypass any zone you cannot close , the <Ready
Byp> indicator flashes indicating bypassed zone(s) . For details see page 9.
Note: Bypassed zones are not protected.
• Arming the System
Before leaving premises the system has to be armed.
When the system is Ready , indicator is lit , enter user code and then <ENTER> to arm
the system.
There is a exit delay prior to the system being armed. During this delay time, a slow
beeping is heard to indicate that the system is not armed yet and reminds you to leave the
protected area.
The A indicator lights up to indicate that the system is armed.
(The indicators may go out few seconds after exit delay expired , depending on the
installer's setting).
If you must disarm the system during the exit delay, press <ARM>.
• Quick Arm (When enabled by the installer)
When the system is Ready , press <ARM> to arm the system.
The A indicator lights up to indicate that the system is armed.
During exit delay time, a slow beeping is heard to indicate that the system is not armed yet
and reminds you to leave the protected area..
• Disarming the System
Enter User’s code and press <ENTER>. The A indicator goes off to indicate that the
system is disarmed.
• Stopping Alarms
In case of alarm condition , Enter User’s code and press <ENTER> to stop alarm any
time.
To Next Page
Loading...
