Need help?Do you have a question about the Crow Power Wave - 8 and is the answer not in the manual?
Outlines the steps to enter the installer programming mode.
Describes how clients can access their programming mode.
Explains how to restore the system to its original factory settings.
Details how to change, add, or delete user codes.
Defines the permissions and access levels for different user codes.
How to set and manage the installer's access code.
Steps to enter and navigate the LCD keypad programming mode.
Introduces the mapping of output modifiers for the system's outputs.
Details various output options like invert, flash, pulse, and siren driver.
Specific options for how outputs behave during 24-hour zone alarms.
Maps zone alarms in the ARMED state to specific outputs.
Configures single EOL or dual zone inputs for panel expansion.
Configures entry and exit delay times for system arming and disarming.
Enables and configures panic button functions on keypads.
Enables and configures fire and medical alarm functions via keypad buttons.
Guides on how to add wireless detectors to the system.
Configures the type of wireless detector used for each zone.
Configures how remote control buttons perform arming and disarming.
Assigns remote control buttons to control outputs or trigger panic alarms.
Enables and configures the dialler's basic functions and settings.
Configures reporting of events like duress, mains fail, and battery low.
Configures reporting for panic, fire, and medical alarms.
Sets reporting for open/close, stay mode, and 24-hour alarms.
Sets the reporting format (Contact ID, Pager, etc.) for telephone numbers.
Configures general panel functions like tamper, lockout, and audible beeps.
Includes functions for writing/reading EEPROM and walk-test mode.
General| Brand | Crow |
|---|---|
| Model | Power Wave - 8 |
| Category | Control Panel |
| Language | English |
To Next Page
