Crow Power Wave - 8 - Viewing the Memory

Page 9
VIEWING the MEMORYVIEWING the MEMORY
If the System light is on, but no other Zone lights are—there are no current System alarms. Arming/Disarming or
reviewing the Memory will turn it off.
When viewing the memory by pressing the “MEMORY” button, the first thing that will always be displayed are
CURRENT SYSTEM FAULTS. Below here are the System fault indications:
KEYPAD LED’s í = Flashing EVENT
System + Œ
LOW BATTERY—System
System + • MAINS FAILURE
Systemí KEYPAD PANIC (or Buttons 1&3)
Systemí + ‘A’í KEYPAD FIRE (Buttons 4&6)
Systemí + ‘B’í KEYPAD MEDICAL (Buttons 7&9)
Systemí + Œ-“í
REMOTE PANIC Buttons 1-8
System + Troubleí + Œ-“í
WIRELESS DETECTOR SUPERVISION FAILURE
Trouble + Ž TELEPHONE LINE FAILURE
Troubleí CABINET TAMPER
Troubleí + Œ-•
TAMPER - Zones 1-4 Short Circuit
Troubleí + •-“
TAMPER - Zones 5-8 Open Circuit
Trouble + Œ-“í
LOW BATTERY – R/C Buttons 1-8
Trouble + ‘A’ & ‘B’í DURESS Code
Area ‘A’ ARMED Area A
Area ‘B’ ARMED Area B
Area ‘A’í STAY Mode Area A
Area ‘B’í STAY Mode Area B
Ready/Bypass + Trouble + Œ-“
ZONE INACTIVITY ALARM Zones 1-8
Ready/Bypass + Œ-“
BYPASED Zones 1-8
Œ-“
OPEN Zones 1-8
Œ-“-
LOW BATTERY - Wireless Zones 1-8
Zone LED System Fault
u
Battery Low
•
Mains Failure
Ž
Telephone Line Failure
•
Wireless Detector Battery Low
•
Remote Control Battery Low
‘
Wireless Detector Supervision Failure
’
Zone Inactivity Timeout
“
Dialler failed to get a Kiss-off
Following the display of current system alarms the panel will then sequence through the 127 historical memory
events starting at the most recent event.