Crow Power Wave - 8 - DIALLER REPORTING OPTIONS; Upload;Download Panel Code; Dialler Reporting Options 1

Page 34
Upload/Download Panel Code
The upload/download panel code number must be entered if the panel is set for auto-answer as this provides a
security access level to the panel. The number can be up to 8 characters in length. Valid characters for this number
are 0-9,B-F (refer to the chart on page 38).
505 Panel Number - 8 characters
Dialler Reporting Options 1
186 ΠReport Duress Alarm - Default on
• Report Mains Fail - Default on
Ž Report Battery Low - Default on
• Report Wireless Battery Low - Default on
• Report System Tamper - Default on
‘ Report Telephone line Failure - Default on
’ Report Supervised Wireless Fault - Default on
“ Report Zone Inactivity Alarm - Default on
Option ΠDuress Alarm to Central Station - If a duress alarm is created the panel can report the unsetting of the
alarm under duress to a Central Station if this option is on.
Option • Report Mains Fail - If a mains failure is detected the panel will report this alarm to a Central Station if
this option is on.
Option Ž Report Battery Low - If a battery low is detected the panel can report this alarm to a Central Station if
this option is on.
Option • Report Wireless Battery Low - If a Wireless battery low is detected the panel can report this alarm to a
Central Station if this option is on.
Option • Report System Tamper - If a control panel tamper is detected the panel can report this alarm to a
Central Station if this option is on.
Option ‘ Report Line Failure - If a telephone line failure is detected the panel can report this alarm to a Central
Station if this option is on.
Option ’ Report Supervised Wireless Fault - If a supervised Wireless device fails to report to the panel within
a preset time then a Wireless failure is registered. If this option is turned on then the alarm will be
reported to the Central Station.
Option “ Report Zone Inactivity Alarm - If a Zone is Monitored for Inactivity (Address 150) and the inactivity
timer for that zone times out (Address 240) an alarm will be generated. If this option is turned on then
the alarm will be reported to the Central Station.