Page 36
Voice Board Messages
This block of addresses (251 - 258) are used to select a voice message that a Zone/24 Hr Alarm will transmit. For
this option to work the optional Voice Board Must be fitted. If a value of “0” or the “Bypass” button is entered at any of
these addresses then the zone will not report via the Dialler in either Voice or Domestic modes.
251 Zone 1 Voice Message Number - (Default = 1)
252 Zone 2 Voice Message Number - (Default = 1)
253 Zone 3 Voice Message Number - (Default = 1)
254 Zone 4 Voice Message Number - (Default = 1)
255 Zone 5 Voice Message Number - (Default = 1)
256 Zone 6 Voice Message Number - (Default = 1)
257 Zone 7 Voice Message Number - (Default = 1)
258 Zone 8 Voice Message Number - (Default = 1)
259 Panic Alarm Voice Message Number - (Default = 1)
260 Fire Alarm Voice Message Number - (Default = 1)
261 Medical Alarm Voice Message Number - (Default = 1)
262 Battery Low Voice Message Number - (Default = 1)
Start Message Number for DTMF Telephone Control
This address (250) sets the start message for the DTMF Telephone control messages. The control messages are set
in a fixed sequence (refer to the addendum sheet supplied with the 90 second voice board for this list). If the voice
board is being used to indicate normal alarms using voice messages and DTMF Telephone control, the alarm
messages must be recorded first.
250 Start of DTMF Telephone Control Messages - (Default = 0)
Voice Board DTMF Telephone Control Codes
This block of addresses (334 - 337) are used to program the 4 digit DTMF Telephone Control Codes. These codes
allow a valid user to Set or Unset the alarm, turn outputs On or Off or enable the Microphone input from a remote
Telephone. Please refer to the User Operating guide or the sheet supplied with the voice board for the full
operational sequence
334 DTMF Telephone Control Code for Area “A” - 4 Digits (Default = 0)
335 DTMF Telephone Control Code for Area “A” - 4 Digits (Default = 0)
336 DTMF Telephone Control Code for Outputs - 4 Digits (Default = 0)
337 DTMF Telephone Control Code to turn on Microphone - 4 Digits (Default = 0)
Contact ID Code - Zones
This block of addresses (321 - 328) are used to set the Contact ID code that a Zone will transmit in an alarm. If a
value of “0” or the “Bypass” button is entered at any of these addresses then the zone will not report via the Dialler.
321 Zone # 1 Contact ID Code - 3 Digit Number (Default = 130)
322 Zone # 2 Contact ID Code - 3 Digit Number (Default = 130)
323 Zone # 3 Contact ID Code - 3 Digit Number (Default = 130)
324 Zone # 4 Contact ID Code - 3 Digit Number (Default = 130)
325 Zone # 5 Contact ID Code - 3 Digit Number (Default = 130)
326 Zone # 6 Contact ID Code - 3 Digit Number (Default = 130)
327 Zone # 7 Contact ID Code - 3 Digit Number (Default = 130)
328 Zone # 8 Contact ID Code - 3 Digit Number (Default = 130)
To Next Page
Loading...
