16
How to Change Master Code
While in client mode ,Press <PROGRAM> and 1 to change Master code press <ENTER>,
the code digit will be flashed back to you . Use the numeric keyboard to enter your new
Master code. The code can hold any combination of 1 to 6 digits. It is recommended using
a multi-digit code. . Press <ENTER> to save your new code , the new code will be flashed
to you and 3 short beeps to indicate correct entry or 1 long beep if not accepted. Press
<PROG> and <ENTER> exit user Code Program mode.
How to Add or Change User Code
While in client mode, press <PROGRAM> and the User number (2 to 10) to add or
change the code ,press <ENTER>. If there is an existing code already, it will be flashed
back to you. Use the numeric keyboard to enter the new code. The code can hold any
combination of 1 to 6 digits. Entering the new code will delete the old code. Press
<ENTER> to save your new code , the new code will be flashed to you and 3 short beeps.
Repeat the procedure for all users .
Press <PROG> and <ENTER> to exit Local Program mode.
How to Delete User Code
While in client mode, press <PROGRAM> and the User number (2 to 10) you intend to
delete, press <ENTER>. The code will be flashed back to you . Press <BYPASS> to
delete User code. Press <ENTER> to save the change.
Press <PROG> and <ENTER> exit program mode.
How to set Time and Date
The alarm system has an internal clock that may be used to automatically Arm or Disarm
the alarm or turn Outputs On or off. It is also used to identify when events occurred in
memory via the LCD keypad. Should you need to change the Time & Date it must be done
from CLIENT mode.
To change the Time & Date press
Press <PROGRAM> <403> <ENTER> <1-7> <ENTER>
Where 1-7 = the current day (1=Sun, 2 = Mon to 7 = Sat)
Press <PROGRAM> <401> <ENTER> <HHMM> <ENTER>
Where HH = Hour in 24 Hour Format and MM = Minutes
Press <PROGRAM> <405> <ENTER> <1-31> <ENTER>
Where 1-31 = the current date
Press <PROGRAM> <406> <ENTER> <1-12> <ENTER>
Where 1-12 = the current month
Press <PROGRAM> <407> <ENTER> <YY> <ENTER>
Where YY = current year, e.g. 02=2002
To Next Page
Loading...
