EasyManua.ls Logo

Crown XTi Series - Service Manual

Crown XTi Series
167 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Service Manual
XTi Series
找资料学技术,故障求助
请到http://bbs.bjjdwx.com
海量维修资料免费下载

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Crown XTi Series and is the answer not in the manual?

Crown XTi Series Specifications

General IconGeneral
Total Harmonic Distortion< 0.5%
Channels2
Built-in CrossoverYes
DSPYes
Signal to Noise Ratio>100dB
Input Sensitivity1.4V
Input ConnectorsXLR
Output ConnectorsSpeakon, Binding Post
Height89 mm
Input Impedance20 kOhms balanced, 10 kOhms unbalanced
Damping Factor>500
ProtectionShort circuit, overload, thermal

Summary

CEquel Digital Systems Overview

Modes of Operation

Describes various operating modes, entry methods, and operations of the CEquel microprocessor.

Updating Firmware

Details the RS-232 and USB methods for updating amplifier firmware.

Serial Flash Memory Map

Outlines the structure and content of the serial flash memory for the M45PE20 chip.

Protection Features

Explains the amplifier's protection mechanisms like thermal limiting and clip elimination.

Governor Algorithm

Describes the governor algorithm for CEquel, detailing its logic and operation.

XTi Assembly Drawings

XTi1000 BOM PWA

Bill of Materials for the XTi1000 Printed Wiring Assembly (PWA).

XTi1000 Schematic

Electrical schematic diagram for the XTi1000.

XTi2000 BOM PWA

Bill of Materials for the XTi2000 Printed Wiring Assembly (PWA).

XTi2000 Schematic

Electrical schematic diagram for the XTi2000.

XTi4000 BOM PWA

Bill of Materials for the XTi4000 Printed Wiring Assembly (PWA).

XTi4000 Schematic

Electrical schematic diagram for the XTi4000.

Firmware Notes

Crown XTi Software Release Notes

Details changes and bug fixes for Crown XTi firmware version V1.1.5.6.

Crown XTi Known Issues

Lists known issues and workarounds for Crown XTi amplifiers and firmware.

About the CLoader Utility

Explains the purpose and usage of the CLoader utility for firmware updates.

About the amplifier “Diagnostic Mode”

Describes how to enter and navigate the amplifier's diagnostic mode.

Tech Notes

Tech Note #181 Audible tone on output.

Procedure to resolve an audible tone on output for specific amplifier models.

Tech Note #183 DSP Clock Drop out.

Procedure to address DSP clock drop out issues by replacing a specific capacitor.

Tech Note #184 Discharge resistor modification procedure

Details a modification procedure involving a discharge resistor for safety purposes.

Tech Note #186 XTi4000 does not appear in System Architect

Solution for XTi4000 amplifiers not appearing in System Architect.

Tech Note# 187 Electrolytic Capacitors C47 and C48

Identifies a defect causing fluid leaks from specific capacitors, potentially damaging the board.

Tech Note# 190 XTi;CDi;DSi Display boards

Procedure to replace display boards for erratic volume or intermittent audio issues.

Related product manuals