To Next Page

To Previous Page

DigiAir Pro 3

Step 4 - Testing

Before leaving site you must test the DigiAir Pro 3 device as per these steps.

1 - Place device on test at the ARC and send a range of signals from the panel

2 - Perform a path test by tapping button C whilst in quiescent/normal state

3 - LED 3 will ﬂash to show signals are being sent

4 - Check signals are received at the ARC

See Troubleshooting for further details.

Other manuals for CSL DigiAir Pro 3

Questions and Answers:

Need help?

Do you have a question about the CSL DigiAir Pro 3 and is the answer not in the manual?

General