CSZ MicroClimate Series - Page 13

SAFETY - PRECAUTIONS AND FEATURES
Page 1-3
Window frame may become hot during operation.
DO NOT put corrosive substances into the chamber examples of corrosive substances
include, but are not limited to, Chlorine, Chlorides and Acids.
DO NOT place items in the chamber which can emit corrosive vapors or substances.
There are NO provisions for venting fumes.
To prevent damage to your test samples and the chamber's compressors, DO NOT
exceed the live load rating of the chamber. (See the General Description Section of this
manual for the Live Load rating for your unit.)
Running Temperature/Humidity points outside of the standard range can cause damage
to the refrigeration compressor(s).
High Voltage remains present when the chamber standby/on switch (if equipped) is
in the standby position. The standby position does not remove power from the main
electric panel.
Do not place any objects on top of the chamber. Don't climb on top of chamber.
All loads must be removed from chamber prior to transport and/or maintenance and
servicing. Do not attempt to move the chamber with the chamber door open.
Only qualifi ed maintenance personnel should be permitted to perform any
maintenance and installation procedures.
To prevent hazards to operators and other personal, read the installation manual in
its entirety. If there are any questions regarding the information in the manual, please
contact Cincinnati Sub-Zero.
Do NOT position chamber so that it is diffi cult to operate disconnect device.
If the equipment is use in a manner not specifi ed by the manufacturer, the protection
provided by the equipment may be impaired.
DO NOT remove lid without referencing Installation section for proper procedure.
The safety of any system incorporating the equipment is the responsibility of the
assembler of the system.
GENERAL SAFETY PRECAUTIONS
CAUTION
!
CAUTION
!
CAUTION
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!
WARNING
!