OPERATION
Page 3-7
SUMMARY FOR STEP-BY-STEP SET-POINT
OPERATION - F4 CONTROLLER (Optional)
These instructions will enable the operator to use the Watlow F4 Programmer/
Controller in a single set-point operation. The User's Manual for the Watlow
F4 Programmer/Controller (found on the digital media that accompanied your
unit) should be reviewed for more detailed operation.
Single Set-Point Operation - Temperature
1. For 115V units, plug the chamber into the proper electrical receptacle.
On MCBH units this will supply power to the Watlow F4 Controller,
Product Hi/Low Limit (optional) and chamber light (optional). The Watlow
F4 controller will turn on immediately and perform a 5-10 second self test.
Wait for completion of self test. For MCH-3 units, turn on the main power
switch on the front of the chamber to supply power to the controller.
2. On MCBH units the system is turned ON/OFF through digital output #1. To
turn the conditioning system ON/OFF:
Use the ! " up and down arrow keys to navigate through the lower
display and place the arrow cursor on the digital out $ eld.
a. Use the % right arrow key to enter the digital out $ eld.
b. Use the % right arrow key to Event output 1.
b. Use the ! " up and down arrow keys to select ON/OFF.
b. Use the % right arrow key to set the system ON/OFF.
c. Use the & left arrow keys to exit the digital out$ eld and return to the
main page.
3. Use the arrow keys (up * down) to change the temperature set-point as
follows:
Use the ! " up and down arrow keys to navigate through the lower
display and place the arrow cursor on setpoint 1.
a. Use the % right arrow key to enter the setpoint $ eld.
b. Use the ! " up and down arrow keys to change the setpoint.
c. Use the % & right or left arrow keys to exit the setpoint $ eld.
4. To turn on the humidity system, follow steps 2 and 3 above to turn on
digital output 2 for humidity and adjust setpoint 2 for humidity.
The following start-up
instructions are written for
the Watlow F4 Controller. For
optional controller, please
refer to Speci$ c Instructions
in the controller manual.
NOTE
To Next Page
Loading...