Chapter 4. Control Port Operation
61
November 2001
In cascade mode, the unused timeslots will pass through their
received data. Enter 2 to turn cascade mode ON, 1 to turn cascade
mode OFF or ESC to exit to the Define E1 Line Parameters menu.
Press ESC and enter 4 to define the Idle code for the E1 line.
<< Define E1 Line Idle Code >>
Idle Code : 7E
Enter Code (00~FF) :
Enter the new Idle code with the hex value 00~FF, or to exit, press
ESC. Press ESC and enter 5 to enable or disable RAI (Remote
Alarm Indication) for the E1 line.
<< Define E1 Line RAI Parameter >>
RAI : DISABLE
1. Disable
2. Enable
Enter 1-2 or Press "ESC" to previous menu.
Press 1 to disable, 2 to enable RAI, or press ESC to exit without
changing. Press ESC and enter 6 to define the E1 Line code.
<< Define E1 Line Code >>
Line Code : HDB3
1. HDB3
2. AMI
Enter 1-2 or Press "ESC" to previous menu.
To Next Page
Loading...
